I just picked up a DFF1 and want to connect my RDP148 to a Cradlepoint MBR1000 hub where the DFF1 is connected. I get a link status for the DFF1 and I can ping it from my desktop. I do not get a link status on the RDP148 nor can I ping it at the IP address it is set for. I have put a multimeter on the cable and pin 1 thru 3 go to pin 1 thru 3 on the RJ45 side and pin 4 goes to pin 6 on the RJ45 side. Should be a straight through cable.
Is there some way to test that the network port is working properly? Have I missed something in the setup of the network port?
I didn't find the right solution from the Internet.
Construction Service marketing example
I think this is an informative post and it is very useful and knowledgeable. therefore, I would like to thank you for the efforts you have made in writing this article. STOCKS TO TRADE
This website and I conceive this internet site is really informative ! Keep on putting up! STOCKS TO TRADE
I am always searching online for articles that can help me. There is obviously a lot to know about this. I think you made some good points in Features also. Keep working, great job STOCKS TO TRADE
I think about it is most required for making more on this get engaged STOCKS TO TRADE
There is definately a great deal to know about this subject. I like all of the points you've made. STOCKS TO TRADE
Thanks for sharing this information. I really like your blog post very much. You have really shared a informative and interesting blog post with people.. STOCKS TO TRADE
Your music is amazing. You have some very talented artists. I wish you the best of success. STOCKS TO TRADE
Really nice and interesting post. I was looking for this kind of information and enjoyed reading this one. STOCKS TO TRADE
I think it could be more general if you get a football sports activity STOCKS TO TRADE